I have been experimenting using a stock from the box (except removed power LED) Nano ESP32 with low power modes. In light sleep I've gotten the 3.3V current, measured at SJ1, as low as 1.27mA. This is about 3x higher than I would expect based on data sheet typical current for the SoC and memory. See Light sleep post
In deep sleep mode the situation is even worse. The lowest 3.3V current I've achieved is 1.78mA. Yes, 0.5 mA higher than in light sleep, and over 100x higher than expected for deep sleep based on data sheet typical currents. The deep sleep current started even higher until I noticed that the pins connected to the external SPI FLASH were all floating in deep-sleep. After many unsuccessful attempts to get the SPI lines to hold high in deep sleep via software, I bit the bullet and added 6x external 10k pull-up resistors to the SPI FLASH pins on the Nano board. This reduced the deep sleep current to 1.78mA.
Has anyone achieved reasonably low power consumption in either light or deep sleep using the Nano ESP32 board ?
FWIW - I've reported this issue to Arduino, They say they will investigate, but meanwhile suggested posting to this forum.