Problem with wiring and coding

Projects General Guidance
1

Hello every one my deliverable is after tomorrow and i'm new to arduino i did my best but i need to make sure if it is right or not .
the circut is down below.

the code is :

#include<LiquidCrystal.h>
LiquidCrystal lcd(0,1,2,3,4,5);
int ldr1=9;
int ldr2=10;
int person=0;
int count=0;
float count1;
int sensorValue=0;
void setup() {
lcd.begin(16,2);
lcd.clear();
lcd.setCursor(0,0);
pinMode(ldr1,INPUT);
pinMode(ldr2,INPUT);
pinMode(sensorValue,INPUT);
Serial.begin(9600);
}

void loop() {
if(digitalRead(ldr1)==HIGH&&digitalRead(ldr2)==LOW)
{
delay(100);
if(digitalRead(ldr1)==LOW&&digitalRead(ldr2)==HIGH)
{person+=1;
}
}
if(digitalRead(ldr2)==HIGH&&digitalRead(ldr1)==LOW)
{
delay(100);

if(digitalRead(ldr2)==LOW&&digitalRead(ldr1)==HIGH);
}
}
if(ldr1==LOW&Ldr2==LOW);
{
print();
}
void print1()
{
lcd.setcursor(0,0);
lcd.print("person:");
lcd.print(person);
}

thankyou

Screen Shot 2016-04-12 at 7.08.43 PM.png
Screen Shot 2016-04-12 at 7.08.43 PM.png972×655 191 KB

2

Your LCD constructor does not match your drawing.
LiquidCrystal lcd(0,1,2,3,4,5); Can't use RX and TX for the LCD and Serial, anyway.

The constuctor for the LCD in the drawing is

LiquidCrystal lcd(12,11,2,3,4,5);

And RW needs to be connected to ground.

I suggest that you write a simple bit of code or use an example from the library to get just the LCD working before moving on.

3 
if(ldr1==LOW&Ldr2==LOW);

Couple of these.
Oops.
And nine is never going to equal zero in a month of Sundays.

I also suspect mismatched braces and missing code tags.
Actually, I don't suspect the latter, I know it.

4

How to write it :frowning: ?

5

Dhai:
How to write it :frowning: ?

First, you have to define what it is you want to do.