Problems with esp32-s3-cam

Other Hardware 3rd Party Boards
1

When I run the Arduino sample program with the ESP32-S3-CAM, there is no output in the serial monitor.
And when I pressed the reset button, the output is:

ESP-ROM:esp32s3-20210327
Build:Mar 27 2021
rst:0x1 (POWERON),boot:0x8 (SPI_FAST_FLASH_BOOT)
SPIWP:0xee
mode:DIO, clock div:1
load:0x3fce2820,len:0x116c
load:0x403c8700,len:0xc2c
load:0x403cb700,len:0x3108
entry 0x403c88b8

It was supposed to be the ip so I can have access to the camera on my computer.

cc352fe1d0c0c94f2e8166a6dcde7159
cc352fe1d0c0c94f2e8166a6dcde71591919×1079 117 KB

1b66169ac5edc3468bda7d614d31a96b
1b66169ac5edc3468bda7d614d31a96b1920×1046 144 KB

02f63114c9ecdbca5139bf3b6b158482
02f63114c9ecdbca5139bf3b6b1584821920×1046 134 KB

2

Your topic does not relate to the Arduino Nano ESP32 board en therefore has been moved to a more suitable category of the forum.

3

If your ESP32S3 board has two USB ports, try programming with the other one.

4

I don't know that module but Is the ESP32-S3-EYE from Espressif the same (or fully compatible) as your ESP32-S3-CAM ?