Two wires for the same SCL and SDA pin on Adafruit Feather M0 Bluefruit?

[pbricks132]

I built an accelerometer that I am trying to fit into a 3D printed case. It works great on the breadboard but I need two wires going from each SCL and SDA Pin in my Adafruit Feather M0 Bluefruit LE, one of each to the feather wing adalogger, and one of each going to the triple axis accelerometer (LIS3DH). How exactly do I solder two wires to the same pin hole?

EDIT: I just realized that I will also need multiple wires for the power and ground pins, I assume it will work the same as for the SCL and SDA pins?

If there is any other needed information I'd be happy to give it, and if this is posted to the wrong topic please let me know, I am pretty new to this arena.

[jremington]

@pbricks132

How exactly do I solder two wires to the same pin hole?

I strip the wires and twist them together tight enough to fit into the same hole.

Edit: are you are talking about a breadboard "hole"?

The Qwiic and Stemma connectors and sensor modules sold by Sparkfun and Adafruit make this task much easier. You have one already, shown in the photo.

[pbricks132]

No, I was using the breadboard to make sure everything would work together, the next step is to take it off the breadboard and move it into a 3D printed case, so the breadboard will not be in the final design.

[LarryD]