Continuing the discussion from Upload fails: "stk500_recv(): programmer is not responding"a : I have the same basic problem uploading a sketch to a Nano. I have pasted the error message below. I have tried the different solutions to no avail. To rule out a computer glitch I connected a Uno R3 an…

Hi @chipstew . This error might be caused by having the wrong port selected from the Tools > Port menu in Arduino IDE. Please perform this experiment to verify that the port you have selected is your Arduino board: Disconnect the USB cable of the Arduino board from your computer. Select Tools > Po…

OK Followed your suggestion and did get a new port listing. Set that port, and ran it again. Exactly the same problem, I Also had the same problem when I clicked on Get Board Info. "Native Serial Port can't obtain info."

See my follow up above. Any idea

Upload fails: "stk500_recv(): programmer is not responding"

Development Tools Uploading

sterretje April 17, 2024, 7:39am 5

@chipstew , I can not find if you tried the "old bootloader" option under tools / processors. There are three options, try all three.

Programmer is not responding

Topic		Replies	Views
Hung on uploading Uploading	5	138	September 25, 2025
Upload to Nano fails: "avrdude: stk500_recv(): programmer is not responding" Uploading	13	318	September 6, 2024
I cant upload my code to arduino nano This is my first code to this arduino nano. I tried the old bootloader also Uploading	31	433	October 12, 2024
Problems uploading sketch Uploading	7	262	December 12, 2024
Upload fails: "avrdude: stk500_recv(): programmer is not responding" Uploading	12	285	February 20, 2025

Upload fails: "stk500_recv(): programmer is not responding"

Related topics