Using a Redbot board with S4A

I am involved in an educational project using Arduino robots. Recently I have stumbled upon Scratch 4 Arduino (s4a.cat), or S4A for short, that allows interaction with an Arduino through drag'n'drop block programming. I have tested it using an Arduino UNO R3 and it worked fine. For our project, however, we intend using a Redbot board (https://www.sparkfun.com/products/12097) which is compatible with the Arduino IDE.

In order to use S4A, it is needed to upload a firmware to the Arduino board, which can be found in http://vps34736.ovh.net/S4A/S4AFirmware15.ino.

The problem is that I have no idea if the Redbot board supports the firmware code. Have anyone here already tried to use S4A with this board? I'd appreciate some help a lot, since I am quite newbie-ish in electronics and only know some Arduino basics.

The problem is that I have no idea if the Redbot board supports the firmware code.

Try it and see. If it doesn't work, upload a different sketch.

Reading the product discription will tell you, it told me!

Mark