wlan.active(True) hang up for Arduino RP2040 Connect

Official Hardware Nano Family Nano RP2040 Connect
4

Hi @ptillisch , thx for your response.

For trying to update the firmware from 1.4.8 to 1.5.0. I did try different way of working as below:-

  1. Use the CLI command line updater to directly do the update - failed
  2. Use the Arduino build in IDE (version 2.3.2) to do the updating - failed. Please see the capture below :-

Capture
Capture735×392 11.4 KB

By the way, I have gone a lot of messages at this forum, seems this issue is kept on-going and no solid solution yet.

My application target to using MicroPython. Right now for the WiFi part, I proved it works using the combination of NINA@1.4.8 + MicroPython@1.18. But I sure that is it not the good combination as both of them are already outdated. MP@1.18 doesn't support to lit on the RGB LEDs :frowning:

So, it is the best if I can update the NINA to 1.5.0.

Regards
Cimiy