Has anyone done this?
So many steps...
So you need to duplicate the example and then configure the Brick with device ID and Secret code etc. Did that.
Then ran it. Not working.
Couple of questions. I CANNOT see in either the Python or Sketch code the delay time for the blink (which you see in the example for simple blink - 1 second).
So when I run the "Copy of LED Blink over Cloud" app, the LED just stays lit......how can it blink without a delay time?
Also, I did all that was required to set up the cloud connection with the dashbord on the Arduino Cloud website. The dashboard is just a switch. But I cant see either the Cloud dashboard and board are interacting with each other? Wasn't that the point?
Anybody help would be appreciated.
Cheers from Sydney