Schönen Abend,
ich wollte eben mein Programm auf den Nano Every hochladen, jedoch erscheint nach 2 Minuten Hochladen folgende Fehlermeldung:
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x37
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x37
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x37
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x37
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0x37
avrdude: stk500_recv(): programmer is not responding
Problem uploading to board. See https://support.arduino.cc/hc/en-us/sections/360003198300 for suggestions.
avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0x37
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0x37
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x37
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x37
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x37
Ich hab bereits im Arduino Help Center nachgeschaut wie man diese Fehler beheben kann, hab jedoch keine Lösung gefunden - Am Pc oder Kabel liegts nicht, die Reset-LED funktioniert auch, Ports sind die richtigen ausgewählt.
Den Loopback Test kann ich leider nicht ausführen, da das Board bereits auf einem PCB verlötet ist
Letzte Woche hab ich einen Testsketch hochgeladen und da hat alles funktioniert.