Blend Micro Interfacing

Hello everyone,

I would like to know how to use the Blend Micro board from Seeedstudio, specifically the Bluetooth connection. Any help would be welcome.

The Blend Micro is compatible with the official Arduino Micro I think.
You can connect the Bluetooth to pin 0 (RX) and pin 1 (TX) and use it to communicate with other Bluetooth device.

Or do you want to upload your sketch ? That is not possible with an Arduino Micro, because of it's USB interface. Perhaps with an other bootloader that uses the pin 0 and 1. I think I have read that others used a special bootloader for it, but I don't know if that was a good and stable bootloader.

Thank you. Although I meant about the built-in Bluetooth. I would like to know how to use that.

I would like to know how to use the Bluetooth functionality.

Have you read all the documentation ?

Have you seen the link to this page with even more information ?
http://redbearlab.com/blendmicro
On that page is also a link to a Blend Micro forum.

Thank you.