Can't Get AT Commands to appear in serial monitor for HM-10 or HC-05

[groundFungus]

For the HC-05 the method in my tutorial work for all the HC-05 modules that i have tried.

Setting HC05 (ZS-040) to AT mode [code example]

I have used the following instruction to put HC05 (ZS-040) modules into AT mode to make changes to your setup. Also at least 3 other members have used this instruction with success. This instruction is for the HC05 module marked ZS-040 connected to an Arduino Uno, Nano or any mega328 based board. Connect the HC05 as shown in the Martyn Currey page on AT mode for the HC05 (ZS-040) in my prior post. HC05 TX to Arduino pin 2 and HC05 RX to Arduino pin 3 (through voltage divider). To change the b…

I have not used the BLE HM-10.