Continuous Data Transfer to Mobile

Hi, I have just started Arduino programming a few days ago and now I want to transfer potentiometer reading to a mobile device. I am using Arduino Leonardo and Bluetooth Mate Silver and the following code to transfer data:

#include <SoftwareSerial.h>  

int bluetoothTx = 2;  // TX-O pin of bluetooth mate, Arduino D2
int bluetoothRx = 3;  // RX-I pin of bluetooth mate, Arduino D3
int val;
SoftwareSerial bluetooth(bluetoothTx, bluetoothRx);

void setup()
{
  Serial.begin(9600);  // Begin the serial monitor at 9600bps
  bluetooth.begin(115200);  // The Bluetooth Mate defaults to 115200bps
  bluetooth.print("$");  // Print three times individually
  bluetooth.print("$");
  bluetooth.print("$");  // Enter command mode
  delay(100);  // Short delay, wait for the Mate to send back CMD
  bluetooth.println("U,9600,N");  // Temporarily Change the baudrate to 9600, no parity
  bluetooth.begin(9600);  // Start bluetooth serial at 9600
}

void loop()
{
  int val = analogRead(A0);

  if(bluetooth.available())  // If the bluetooth sent any characters
  {
    Serial.print(val);  
  }
  if(Serial.available())  // If stuff was typed in the serial monitor
  {
      bluetooth.print(val);
  }
  delay(1000);
  // and loop forever and ever!
}

I found that bluetooth connection estublished without any error, however I am not getting any data on mobile device. I changed the code (e.g., without the if statement/ printing potentiometer data on serial monitor and read the data from serial monitor to the transfer into mobile device), only I get the data in mobile device if I enter any values in serial monitor. I would highly appreciate if anyone could suggest me possible solutions to solve it.