Hello, I am trying to have two DC Motors run for a specific amount of time when a specific button is pressed on an IR Remote. The forward and backwards buttons work fine but when I try to get the robot to turn by having the motors running in opposite directions for a specific amount of time (using t…

I figured it out guys! Trick is to reset millis() to zero (didn't know that was possible) and refer to the code below to run through the logic. Was specifically using the zero button and one button for testing and the variables associated, as well as the if statement at the very end of the program(r…

Having trouble running DC motor for specific amount of time then stopping using milli()

Projects Programming

epwalker97 January 10, 2025, 10:26pm 10

Unfortunately, this code did not do the trick either. Same result.

Topic		Replies	Views
Arduino controlled DPDT with time out program Programming	78	442	December 18, 2025
DC motor met IC besturing Nederlands	70	93	November 23, 2025
Find the error - Code issue to drive CC motor with timer Programming	77	528	November 11, 2025
Problem with timer overflow interrupts Programming	13	844	May 6, 2021
Help needed for using millis and PWM to decrement DC motor speed over time. General Guidance	28	3238	May 5, 2021

Having trouble running DC motor for specific amount of time then stopping using milli()

Related topics