Hi all,
I am able to make connection between Arduino sketch and linux right now.
But I have another problem.
I bought ProtoCentral MAX86150 PPG and ECG breakout about 3 moths ago, I tried to connect that sensor with Portenta X8 but couldn't.
Here is github rep of the sensor:
https://github.com/Protocentral/protocentral_max86150_ecg_ppg
And the getting started document:
https://docs.protocentral.com/getting-started-with-max86150/
And I also dropped my setup below. I use I2C protocol (Black cable to GND, Blue cable to SDA, Yellow cable to SCL and Red cable to VCC)
I think there is no signal from the sensor.
I appreciated if any suggestions.
Thanks
