Und wo und wie schließe ich den ir seder an weil sehe da keine pin belegung drin habe das jetzt so gemacht
/*
* IRremote: IRsendRawDemo - demonstrates sending IR codes with sendRaw
* An IR LED must be connected to Arduino PWM pin 3.
* Version 0.1 July, 2009
* Copyright 2009 Ken Shirriff
* http://arcfn.com
*
* IRsendRawDemo - added by AnalysIR (via www.AnalysIR.com), 24 August 2015
*
* This example shows how to send a RAW signal using the IRremote library.
* The example signal is actually a 32 bit NEC signal.
* Remote Control button: LGTV Power On/Off.
* Hex Value: 0x20DF10EF, 32 bits
*
* It is more efficient to use the sendNEC function to send NEC signals.
* Use of sendRaw here, serves only as an example of using the function.
*
*/
#include <IRremote.h>
IRsend irsend;
void setup()
{
}
void loop() {
int khz = 38; // 38kHz carrier frequency for the NEC protocol
const unsigned int irSignal[68]={4600,4350,700,1550,650,1550,650,1600,650,450,650,450,650,450,650,450,700,400,700,1550,650,1550,650,1600,650,450,650,450,650,450,700,450,650,450,650,450,650,1550,700,450,650,450,650,450,650,450,650,450,700,400,650,1600,650,450,650,1550,650,1600,650,1550,650,1550,700,1550,650,1550,650};
irsend.sendRaw(irSignal, sizeof(irSignal) / sizeof(irSignal[0]), khz); //Note the approach used to automatically calculate the size of the array.
delay(5000); //In this example, the signal will be repeated every 5 seconds, approximately.
}
