I am having very similar problem like this one: [image] Arduino PLC IDE Freezes when Connecting to Opta PLC IDE After downloading the runtime environment and configuring the Modbus port as described in the Setup & License Activation Guide , I'm stuck at step 5. Whenever I …

Ditto.... I have the exact same scenario as DigitalMeth describes above. There does not seem to be a standard solution available.. I don't have a Portenta to try, but don't see a reason to invest in one if the PLC IDE will not connect. This is frustrating to no end.

I solved the first problem by using the 2nd COM port as communication. So for example if when you connect it you get COM port 6, and after downloading the runtime environment COM 7 appears, try using that one. After that some other issues appeared but I was able to clear them through. To me this i…

3 months later and IDE 1.0.7 but still the same problem. Has no one found a solution to the problem?

Then it feels like all hope is gone the solution is found. This worked for me at least Followed: https://forum.arduino.cc/t/opta-sill-not-connecting-to-plc-ide/1230775/15?u=jesper_jonsson and https://forum.arduino.cc/t/opta-sill-not-connecting-to-plc-ide/1230775/16?u=jesper_jonsson

Try to upload and run the Arduino IDE example STM32H747_System > QSPIFormat and then the entire Arduino PLC IDE Process

I had the same freeze when connect issue, Digging through all the post and your reply helped finally. It's just a matter of downloading using the lower port and connecting using the higher port. So many people have the same issue from what I can see from all these posts over months, how is this n…

Having the same issue setting up an Arduino Opta Lite. Using Arduino PLC IDE 1.0.8. Tried both COM ports that shows up, tried regressing to Arduino PLC IDE 1.0.3 based some other forum threads. I have also tried the memory partitioning, but still struggling. So finnicky to just set-up this Arduino …

ins this case, that could help! [image] Arduino PLC IDE Freezes when Connecting to Opta PLC IDE I hope this finds everyone sane, I nearly lost my mind trying to resolve this issue. I was able to fix it by going to: and downloading and running the Opta Facto…

I believe that I have figured out a reliable solution for working with the Opta: Guide for Connecting to Arduino .

PLC IDE and Arduino OPTA - cannot connect

Development Tools PLC IDE

floow1705 December 28, 2025, 9:14pm 9

ins this case, that could help!

Topic		Replies	Views
Arduino PLC IDE Freezes when Connecting to Opta PLC IDE	24	4694	July 9, 2026
Issue with new opta connecting? PLC IDE	5	557	September 21, 2025
Opta Lite cannot connect in Arduino PLC IDE PLC IDE	3	244	December 5, 2025
Arduino Opta - Unable to Communicate via PLC IDE Opta	3	563	August 28, 2026
Arduino Opta PLC IDE - stuck when try to connect Opta	2	192	October 25, 2025

PLC IDE and Arduino OPTA - cannot connect

Related topics