Hi, i recently had problems connecting to Arduino IoT Cloud when uploading a sketch from web editor on my Nano 33 IoT. So i tried to delete my board from Device Manager to set it up again in the "Getting Started" section, but when it comes to configuring the Crypto Chip, it doesn't work, and after 5 minutes it shows this message: "We weren't able to configure the Crypto Chip. Timeout reached before we could configure your board."
How can i fix this?
Same here, have no clue what to do. Except I just got a new board out of the box, so initial setup fails.
Answering myself. There was another topic earlier that seems to address the issue: MKR1000 Arduino Cloud Crypto Issue - IoT Cloud - Arduino Forum
Looks like I need to update firmware. Let's see if that helps 
edit: And it did.