Reciever wiring with multiwii

Other Hardware Sensors
1

when i use the tutorial by electronoobs, i connect my reciever to d2 on my arduino nano but it still does not give any input signals on the multiwii platform.

i am using the same wiring as in the website and rudder servo works, no other one works and is free even when power is applied.I interchanged the servos to no avail.

my reciever is connecting to flyskyfsi6 but signals not showing on transmitter

2

Hello?

3

@johnwasser help

4

ok nobody wanna help

5

Is your flyskyfsi6 receiver configured to send all channels on one wire? That is the PPM signal your flight controller is looking for on D2.

6

Actually it is working and ppl signals are being recieved....tested with code on Internet

8

This topic was automatically closed 180 days after the last reply. New replies are no longer allowed.