I have this LED strip SUPERNIGHT (TM) 16.4FT SMD 5050 Waterproof 300LEDs RGB Flexible LED Strip Light... SUPERNIGHT (TM) 16.4FT SMD 5050 Waterproof 300LEDs RGB Flexible LED Strip Light Lamp Kit + 44Key IR Remote Controller(Power Supply is not Included) : Amazon.co.uk: Lighting …

can you just tape an IR Led over the IR receiver to the LED strip Then tape over with some black / tape which wont let the light through Then you can get your Arduino to turn that IR LED on an off i.e send it the correct commands Alternatively you could take it apart and see whats inside, but som…

In theory yes: You have to make sure the voltages are OK The output of the IR receiver is usually inverted, so you would have to make some tweaks to account for that. The output of IRremote is a modulated signal & the output of the receiver is demodulated and inverted. So you would have to make so…

Remove IR receiver and send commands straight to device with arduino

Projects General Guidance

Topic		Replies	Views
Instead of using iR can I General Guidance	10	148	April 9, 2026
Arduino UNO IR Reader+ Remote General Guidance	7	110	December 28, 2025
REceive ir and send an other General Guidance	2	62	October 1, 2025
IR Remote command disables one side of a Motor Controller Programming	10	118	August 16, 2025
Is it possible to send and receive IR signal in one Arduino UNO? Home Automation	9	245	March 5, 2025

Remove IR receiver and send commands straight to device with arduino

Related topics