hello
i have a project about position control. In my project, servo must turn 5 10 15 20 25 30 35 40 45 50 55 60 degrees. When Motor turns 5 degrees then coming 0 position (e.g 5 0 10 0 15 0) angels adjustment with pot. if you have similar example, can you share me?
Firstly, i am sorry for bad english. i will use 10k pot and angle change by potentiometer. for example, digital value 200 and motor have to run 5 degree clockwise after this, motor must come first position (0 degree). it's my first project at arduino board.
your example tutorial http://arduino.cc/en/Tutorial/Knob is so basic. i used pic series for position control it's easy but i don't have an idea for turn back 0 position so i search example code
but i don't have an idea for turn back 0 position so i search example code
Generally you rotate the pot knob the opposite direction.
Yeah but In think he means, once it's "parked" at the X degree position as dictated by the pot, it must go back to 0 by itself. That, of course, will leave the pot still sitting at the position calling for X degrees so not sure what OP expects to happen then.....