Share tips you have come across

Prototyping Wire Loop Connections using 38 SWG Shellac Insulated Wire

See also:

  • Double Wire Connections on a Prototyping PCB

  • The following is an excerpt from an upcoming PDF.
    Making a Hand Soldered Prototype PCB

  • When soldering Shellac Insulated interconnecting wires, a shellac removing tool can be easily constructed.

  • The tool is made from a small FR4 PCB board, a foil section holds a blob of solder.

  • Heat this solder blob to 400°C, insert the end of a shellac insulated wire, the shellac burns off.

  • It takes only a few seconds to burn off the insulation, the wire is ready to solder to a prototyping PCB pad.

  • A small hole is drilled in the board to aid in solder removal from the wire loop.

  • Below is an image of a Jig which holds our Prototyping Board.
    At the front is the Shellac Removing Tool held in place with M2 hardware.
    The jig lays on a non-slip piece of silicone and is clamped to a Teflon covered stainless-steel work surface by a magnetic hold-down clamp; the stainless-steel working surface is earth grounded.

  • As mentioned, this will be covered in a future PDF.

  • The following images should be self explanatory.