“A method for doing something might not work in all situations.”
This discussion shows two methods for removing SMD components.
‘Desoldering Spatulas’
Material:
- magnetic hold-down clamps sitting on a 403 stainless steel work surface
- Aluminum strips cut from a soda can (these will have a thickness of ~4 thou”)
- 60/40 solder
- silicone non slip strip
- Acetone for cleaning
- utility knife
When we need to remove a multi lead component it can be quite challenging.
A strip of aluminum can be slid under heated component leads to separate them from their pads.
Practice makes perfect.
Note to self: Get some .002" stainless steel shim stock and try it.
Apply ‘Liquid Flux’ on the leads to aid in solder melt.
If needed, place Kapton tape on either side of the resistor to shield solder splashes.
EDIT
See posts #750 and #776
