Hello Everyone,
I just received my SmartElex GPS Data Logger Shield, and I want to use it with Arduino Mega 2560.
Would someone be kind enough to point me to a suitable, basic sketch to start using the shield and log data in the SD card.
There is very little documentation that came along with the shield. Here is what I received -
QUOTE
In this shield, GPS Serial communication pins can be switched between Arduino hardware serial pins D1, D0 and for software serial library D9, D8 by DPDT Switch.
Pin Configurations:
Jumper Pin Name Arduino Pins
J1 SCK D13
J2 MISO D12
J3 MOSI D11
J4 F_ON D10
J5 SW_TX D9
J6 SW_RX D8
J7 GPS_RST D7
J8 CS D4
J9 HW_TX D1
J10 HW_RX D0
UNQUOTE
Thank for you help
Ajay