AITRIP Pluggable Development Board Attiny85 (without the chip)

[electrocopy]

Hello,

I am new to Arduino. I purchased the AITRIP Pluggable Development Board for ATtiny13A/ATtiny25/ATtiny45/ATtiny85 Programming Editor Micro USB Power Connector on Amazon. link here:https://www.amazon.com/dp/B08P57QH7R?ref=ppx_yo2_dt_b_product_details&th=1
I fail to install windows 10 drivers from the link in github. I get a message that windows drivers are the best for this device.

My questions are:

1. I can program the ATTINY85 with Arduino IDE conected to windows without arduino hardware?
2. if yes do I have to place the attiny85 (without bootloader) chip before I connect to windows?
3. is it a digispark compatibale board?
4. if yes what am I doing worng?

Please direct me to a detail instruction about the exect board I am using.

Thanks Much.

Ben.

[reidstr529]

I too have this exact same board. I am confused by the printing on the back of the board that refers to the 8 pinouts on the 8 pin connector that gets soldered in.

As you can see, the labels on the back are not the same as the published pinouts. This is why I am confused, which ones should I use?
Thanks
Rick