Hi,
this is my first post on this forum, so first of all - hello everyone:-).
I've just bought my first arduino board (nano v3.0) and successfully connected it to a PC. It seems to be working (I can blink LED on port 13 and it works fine). However when I'm checking voltage between 5v pin and ground pin the result is 0. The board is powered via usb cable.
Is there anything I should do to get voltage on 5v pin? Or maybe I have a broken board?
Regards
Dwukwiat
(Assuming that this is the Arduino Nano sold by Gravitech and you're making competent use of the voltmeter --)
dwukwiat:
Is there anything I should do to get voltage on 5v pin?
No.
dwukwiat:
Or maybe I have a broken board?
Bad "auto selector" diode [D1 - between "+5V" and "VUSB"?
That's about all that it could be.