Doubt about connection between Type S Load Cell and Arduino

[lidianerimesss]

Hello, everyone. Can someone explain how can I connect a Type S Load Cell in my Arduino? The sensor has 6 wires, different of the others. I need to use HX711 module. The cell model is annexed.

[GolamMostafa]

Do you know the signal signatures of these six wires? If yes, then show it; else, get this information and post it here.

Read the Load Cell name plate and post its type number.

Check carefully, there are 6 wires or 4 wires.

[flashko]

Your picture is small and maybe I can't see well but where are these 6 cables? I see only 4 - red, black, green and white.

[Wawa]

@lidianerimesss

The sensor has 6 wires...

I see five wires. The bare one is likely cable shield. (connect to Arduino ground).
Yes, use a HX711.
Try this:
Red E+
Black E-
Green A+
White A-
Leo..

[GolamMostafa]

@lidianerimesss

Hello, everyone. Can someone explain how can I connect a Type S Load Cell in my Arduino?

@Wawa

Try this:
Red E+
Black E-
Green A+
White A-

Here is the connection (Fig-1) among Load Cell, HX711, and UNO:

Figure-1: