ECG/GSR Click board compatibility to atmega2560 and esp32

Other Hardware Sensors
1

Hi to everyone,
I am a newbie and I'm gonna ask something unusual...I hope that I won't be too much off topic.
Does someone know anything about the compatibility of ECG/GSR Click with atmega2560? And what about its compatibility, I imagine through some shields like the one for Arduino Uno(Mikrobus 1581), with ESP32? I am very new with this and don't know how to move..It is very struggling, I don't find any guide or something useful for beginners with this sensing board. Could someone help me, maybe through some links to some examples or material?
I have given a look to some examples in Necto Studio, but unfortunately I didn't find anything for atmega2560 and, at the moment, I have not other micros but atmega2560 and ESP32.
If you tell me that I have not any chance but buying other microcontrollers, then I will take into account buying a new one.

Thank you so much!!

2

If "compatibility" means if you're able to connect this board to an Arduino Mega2560 then it's compatible.
The same applies to the ESP32 but you have to change the soldering bridge in the lower middle part (logic voltage selection).

That's probably because this isn't a board for beginners. Try to get experience with easier projects. Once you know what an I2C bus is and how you handle devices on it you might try this again.

3

This topic was automatically closed 180 days after the last reply. New replies are no longer allowed.