good day to all in this forum,
I am using IDE 2.3.4 and the ESP32 board loaded with OTA. I found that most of the time the network port is not shown under the tools\ports\network ports.
Sometime resetiing the IDE clear the problem but most of the time it does not.
It is wasting time everytime I need to upload new sketches.
Any suggestion , please ?
Thanks
Ambro
I'm on IDE 2.3.4 now since I upgraded my computer (before it was 1.8.16 for ~three years). I have also lots of problems with my OTA capable devices not showing up in the IDE. Sometimes they will be there, then I start upload (which means compile first) and by the time the compile is finished, the device shows "not connected".
I run webserver on all of these devices, and find refreshing that page in my browser sometimes helps.
Have you found a solution in the meantime? I'd be interested to hear