OTA port does not show up

Development Tools Uploading
1

I am not an experienced arduino user but I programmed a few small projects in my spare time. The next project is going to be an ESP base gate motor controller. Since the gate is 300 meters away from the house I want to use OTA for sketch updates. When I upload BasicOTA the network port does not show up although it gets an IP address and can be pinged from the computer. I assume that this is because IoT devices and PCs are in different networks. Is there any way to manually setup the network port for OTA ?

I am using IDE 2.3.3 and mostly AZ-Delivery ESP32 Uno.

Thanks - m.

2

This topic was automatically closed 180 days after the last reply. New replies are no longer allowed.