Index The index to this thread is found in post number 903 Go to INDEX. [IMG_3826] How about sharing some tips you use? Here is one I use often when I need my third hand to give a constant pull. [2017-01-04_0-01-26.jpg] .

I don't like soldering wires directly into the PCB holes, because the soldering process makes flexible wire more brittle. If you need to handle the assembly during debugging, you're very likely to have wires break right at the PCB surface, which can lead to damage due to unexpected short circuits. …

A second method consists of crimping the wires onto JST terminals, then bending the connector pins before soldering them. This also provides a very strong attachment that resists pulling forces and vibrations. [image]

In that case, I usually just encase the solder joints, wire, and wire casing all in one large blob of hot glue. Immobilizes everything.

[image] gwion: soldering wires directly into the PCB holes I thread the wires though extra holes I add to the PCB: [image] (I don't know whether that shows up very well. The wires (insulated part) go down through the right-hand vias, and the bare wire comes up through the left-hand hole, …

If you have not added a hole for the wire, a soldered Dupont male crimp pin with heat shrink can be soldered to a pad thus giving strain relief to prevent wire breakage. From post #1196 [D]

Peg Clamp Conversion for Electronic Workbench Use An inexpensive Peg Clamp ($25.00) makes a great small form factor vise for the work bench. A magnet base keeps the clamp secure while being used. The following images show the steps necessary to convert a hand held Peg Clamp to a workbench vise…

You can use M3 x 6mm screws to fasten your Uno to it's baseplate (either the clear one supplied with a genuine Uno, or one of the coloured ones available as a pack of 5 ). [MFG_X000018] However if you try and screw the screw straight into the base, then you will crack the boss. You can get round …

Dupont Jumper Wire Management. Using Binder Clips to hold wires was discussed a while back. [image] Share tips you have come across General Electronics Breadboard Wire Storage The following is the best method I have used to manage wires for my solderless brea…

With aliexpress wires you can simply use a magnet... :slightly_frowning_face:

Or use a few of the thousands of twist ties that multiply in the workshop. I have a 6x10x4 inch bin on the shelf, and it's always full.

Arduino Forum

Share tips you have come across

Other Hardware General Electronics

LarryD May 12, 2025, 6:38am 1408

Peg Clamp Conversion for Electronic Workbench Use

An inexpensive Peg Clamp ($25.00) makes a great small form factor vise for the work bench.
A magnet base keeps the clamp secure while being used.
The following images show the steps necessary to convert a hand held Peg Clamp to a workbench vise.

Topic		Replies	Views
Alternatives to soldering, before I rip all my hair out General Guidance	52	708	September 5, 2025
Some notes about construction Tutorials	80	4387	June 8, 2023
Will this work? Atmega1284p Schematic Hardware Development	230	1176	May 19, 2026
PCB pour robot tondeur Français	93	789	January 19, 2026
I solder "wrong" and it seems better? Fight me? General Electronics	55	2447	May 25, 2022

Share tips you have come across

Peg Clamp Conversion for Electronic Workbench Use

Related topics