Step motor 28BYJ-48

Using Arduino Motors, Mechanics, Power and CNC
1

Hi, I'm a beginner, I have a 28BYJ-48 motor (picture 1) or does this Polla A4988 driver (picture 2) handle its operation? I have an extra CNC screen, all this is needed to put in a buy, but to shield there are 4 pins on the motor and I do not know if the going problem. I ask quite seriously. Thanks for the help in advance.

2

You can use that driver, if you 'hack' the motor a little.

3

So i should cut the one lane and remove red wire?

4

Well, we generally call them 'traces' and not 'lanes'. :o

So yes, cut the one trace, and ignore the red wire.

Hook up the other 4 wires to the outputs of the driver.