Terminal Connector

A quick question on there 2.1mm connectors http://www.ebay.com/itm/311751738289?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT

It says "It will take 3.2mm push on connectors". I tried searching ebay and google, there doesn't seem to be many results which fit the bill. These are the closest thing which I only guess it's the right one RED FEMALE SPADE 3.2mm x 5mm PUSH ON CONNECTORS ELECTRICAL TERMINALS RF3205VR | eBay

Could someone verify if it is the correct connector?

I think they are saying that those push fit spade connectors would fit the lugs on the back of the sockets. Is that what you wanted them for? I always solder wires to those lugs, and often put a short section of shrink tubing over the lug and first part of the wire, for protection against electrical shorts and mechanical strains.

Yep, that's what I need. I have been working with a lot of these, and so far I have been soldering them all these years. I am hoping to find a quick connect solution for a low current project, which require lots of these.