Hi first post here,, I have an old (2015) Folger Tech delta printer. The bed leveling is at best close (but not close enough) I installed a manual bed leveling system. This raised the bed appox. 20mm, I figured if I raise the bed start height the hot end would stop at the higher start level.... WRO…

Why did you post that question in a section with the description Tutorials for new people on the forum?

Because I'm new and still learning. This is my first time on this forum. G code is my weak point at this time. Maybe it not a G code issue just a setting in the software. What section should I have used? Thank you for your response.

@3dweb your post has been moved as suggested.

Upgraded bed leveling

Other Hardware Motors, Mechanics, Power and CNC

groundFungus January 23, 2022, 9:11am 4

The Motors, Mechanics, Power and CNC category

Topic		Replies	Views
Mega 2560 d3-- RAMPS 1.4 D10 AND D9 POWER on gmax 1.5+ printer, marlin firmware Motors, Mechanics, Power and CNC	26	495	September 21, 2026
Branchement L298N pour perforatrice Français	26	580	October 24, 2026
Schrittmotoren drehen sich nicht Deutsch	32	756	March 2, 2025
Creality CR10-S Pro V2 Motors, Mechanics, Power and CNC	5	270	May 25, 2025
3d printer bed leveling help Device Hacking	5	1014	November 28, 2023

Upgraded bed leveling

Related topics