Hello everybody! I would like to measure the voltage produced by two strain gauges applied on both sides of a flexing bar and connected in Wheatsone bridge configuration. To amplify the signal I bought a HX711 ADC 24-bit module used for load cells and weighting. The problem is that I'm finding all …

HX711 module for strain gauge measurement

Paul_KD7HB November 20, 2020, 4:59pm 2

The HX711 data sheet should give all the information you need.

Paul

Topic		Replies	Views
Wheatstone bridge with hx711 amplifier than arduino General Guidance	11	1645	January 30, 2024
Quarter Bridge Strain Gauge with HX711 Amplifier Sensors	11	4424	May 6, 2021
Measuring strain with 2 straingauges, 3296W variable resistor, HX711, Arduino General Electronics	3	208	December 10, 2024
Strain Gauge and HX711 break out board. Sensors	2	856	May 6, 2021
Is this the correct circuit for a Wheatstone Bridge? General Guidance	5	792	October 7, 2022