Welcome to the forum!
There have already been several topics about this error that have already been solved, so please take a look at them.
Hello,
I am writing to seek assistance regarding an issue I am facing with my Arduino UNO.
Upon attempting to program the UNO, I encountered the following error message:
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0xa1
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0xa1
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 3 …
Programmer not responding Error keeps on occuring. Its Ardiuno UNO Made In Italy.
Board Model: UNO R3
[Screen Shot 2024-09-21 at 13.36.18]
this is the picture of the port.
And i chose the the UNO R4 in the category cause i cant find the UNO R3
I know there're many posts related to this and there're many solutions provided in those posts already, but again I am posting this because none of those solutions works for me.
So, I have a Arduino Uno with the ATMEGA328p that I can't upload sketch onto, when I try to upload I get:
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x00
I have tested the below:
It worked before -- so something happened while it's being used, sa…
These are just a few of the topics that have been created on this error, if you want to see all the topics created on this error, type, "Programmer not responding," into the search bar of the forum.
Hope this helps you!
@rlsieben